Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These tubes go from the case to the heads to house the push rods.
These tubes go from the case to the heads to house the push rods. They also return the oil from the heads to the case. We highly recommend that you replace these whenever you pull the heads off a 1200 through a 1600 engine. The stock tubes have a crush built into each end. If you try to stretch the old ones, they will go back to where they were crushed as soon as they heat up and more than likely leak. Note: You should be careful putting the seals on. It's real easy to cut your fingers. On Buses 1972 on you do not need to replace the old tubes and they can be installed after the heads are on.
Bug (Type 1): 61-65
Bus (Type 2): 60-65
Ghia: 61-66
No customer reviews for the moment.
Part #: 1109401125SC
1.25 Ratio Rockers Pro SCAT
Application:Part #: 113109612A
The two outside valves in the head are the exhaust valves, they let the burned fuel out of the head.
Application:Part #: JC91020
Jaycee Leak proof Pushrod Tubes, Black
Application:Part #: 113101401
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 113109021DBR
We've had no luck with regrinds, therefore we sell only new camshafts.
Application:Part #: 1109603
Stainless steel valves are used in the big valve heads.
Application:Part #: 1109341EA
Push Rod Tubes, Adjustable Big-Mouth, Each
Application:Part #: 1109338
These push rod tubes are spring loaded and are great for replacing bent tubes without having to pull the head(s) off.
Application:Part #: 113109601B
The two inside valves in the head are the intake valves, which let the gas into the combustion chamber.
Application:Part #: 1109302
These push rods are made out of chromoly steel and do not expand at the same rate as aluminum.
Application:Part #: 111101401B
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1109641
If you are going to run dual springs we suggest you use these valve spring retainers as well.
Application:Part #: 1109305
Aluminum Smith Bros. Push Rods
Application:Part #: 113109641B
These springs return the valves back to their seats.
Application:Part #: 1109337
These push rod tubes are spring loaded and are great for replacing bent tubes without having to pull the head(s) off.
Application:Part #: 111109325
Push Rod Guide, 25-36 HP, Each
Application:
These tubes go from the case to the heads to house the push rods.
