Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These push rod tubes are spring loaded and are great for replacing bent tubes without having to pull the head(s) off.
These push rod tubes are spring loaded and are great for replacing bent tubes without having to pull the head(s) off. However, they should be used only in an emergency, as they do leak a little. We found the stock push rod tubes are the best.
Bug (Type 1): 40hp-1600
Bus (Type 2): 40hp-1600
Type 3: 40hp-1600
Ghia: 40hp-1600
Thing: 40hp-1600
Race/Off-Road: 40hp-1600
No customer reviews for the moment.
Part #: JC91040
Jaycee Leak proof Pushrod Tubes, Silver
Application:Part #: 1109399
1.25 Ratio Rockers ONLY
Application:Part #: 1109461
These shims are used under the rockers to set the geometry.
Application:Part #: 113109612
The two outside valves in the head are the exhaust valves, they let the burned fuel out of the head.
Application:Part #: 1109430
These shims are used under the rockers to set the geometry.
Application:Part #: 1109400
This kit eliminates the clips and spring washers in a rocker shaft set up.
Application:Part #: 1109612
Stainless steel valves are used in the big valve heads.
Application:Part #: 1109403
These shims are used with the Solid Shaft Rocker Kit.
Application:Part #: 1109603
Stainless steel valves are used in the big valve heads.
Application:Part #: 11310140102
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 043109611A
The two outside valves in the head are the exhaust valves, they let the burned fuel out of the head.
Application:Part #: 043109451
This screw rides against your valve, opening and closing it.
Application:Part #: 1109337
These push rod tubes are spring loaded and are great for replacing bent tubes without having to pull the head(s) off.
Application:Part #: 1109641
If you are going to run dual springs we suggest you use these valve spring retainers as well.
Application:Part #: JC91030
Jaycee Leak proof Pushrod Tubes, Blue
Application:Part #: 311109601
The two inside valves in the head are the intake valves, which let the gas into the combustion chamber.
Application:
These push rod tubes are spring loaded and are great for replacing bent tubes without having to pull the head(s) off.