Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These rods link the cam to the valves.
These rods link the cam to the valves. If you have used rods, make sure that they are straight by rolling them on a flat surface. Inspect the ends and blow air through the tip making sure it comes out the other side. We do not recommend using steel push rods on a daily driver, because the expansion rate is different and requires you to adjust the valves more often. Note: When installing push rods, squirt some oil on the ends and down the hole.
Bus (Type 2): 2000
No customer reviews for the moment.
Part #: 1109641
If you are going to run dual springs we suggest you use these valve spring retainers as well.
Application:Part #: 1109400
This kit eliminates the clips and spring washers in a rocker shaft set up.
Application:Part #: 1109002USA
Cam Gear without bolts USA Made
Application:Part #: 113101399B
Rocker Arm Stud
Application:Part #: N111521
This screw rides against your valve, opening and closing it.
Application:Part #: JC91030
Jaycee Leak proof Pushrod Tubes, Blue
Application:Part #: 113109612
The two outside valves in the head are the exhaust valves, they let the burned fuel out of the head.
Application:Part #: JC91000
Rebuild kit for Jaycee Leak proof Pushrod Tubes
Application:Part #: 113109601B
The two inside valves in the head are the intake valves, which let the gas into the combustion chamber.
Application:Part #: 111109335
These tubes go from the case to the heads to house the push rods.
Application:Part #: 1109002
Premium Performance Aftermarket Cam Gear
Application:Part #: 022109451
This screw rides against your valve, opening and closing it.
Application:Part #: 1109461
These shims are used under the rockers to set the geometry.
Application:Part #: 1109603
Stainless steel valves are used in the big valve heads.
Application:Part #: 1109651
We have had good luck with stock keepers on single springs.
Application:Part #: 1109001
Engle cams are one of the most popular performance camshafts made for the air-cooled Volkswagen.
Application:
These rods link the cam to the valves.