Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These rocker studs are much stronger than the stock studs and are .100" longer to allow more flexibility when setting your rocker arm geometry..
These rocker studs are much stronger than the stock studs and are .100" longer to allow more flexibility when setting your rocker arm geometry.
Bug (Type 1): 1300-1600
Ghia: 1300-1600
Thing: 1300-1600
Race/Off-Road: 1300-1600
No customer reviews for the moment.
Part #: 1109603
Stainless steel valves are used in the big valve heads.
Application:Part #: 1109006
These gears give just a hair more horsepower.
Application:Part #: 1109410
These shims are used with the Solid Shaft Rocker Kit.
Application:Part #: 111198541BR
The cam rides in these bearings.
Application:Part #: 1109651
We have had good luck with stock keepers on single springs.
Application:Part #: 111109325
Push Rod Guide, 25-36 HP, Each
Application:Part #: 1109341EA
Push Rod Tubes, Adjustable Big-Mouth, Each
Application:Part #: 113109612
The two outside valves in the head are the exhaust valves, they let the burned fuel out of the head.
Application:Part #: JC91030
Jaycee Leak proof Pushrod Tubes, Blue
Application:Part #: 1109461
These shims are used under the rockers to set the geometry.
Application:Part #: 111109335
These tubes go from the case to the heads to house the push rods.
Application:Part #: 1109310
These lifters are made by Engle and have a small hole in the end of them that allows oil to be pumped onto the cam lobe and lifter face.
Application:Part #: 111109601A
Intake Valve 30mm (each)
Application:Part #: 111109611A
Exhaust Valve 36 HP
Application:Part #: 1109451
This style of adjusting screw has a ball with a flat side on the end.
Application:
These rocker studs are much stronger than the stock studs and are .100" longer to allow more flexibility when setting your rocker arm geometry..
