Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
We have found this kit to be a good, cheap dual carb kit for a stock motor.
We have found this kit to be a good, cheap dual carb kit for a stock motor. Throttle bushings wearing out over time is the only bad thing we can say about them. We suggest you change the fuel hose in the kit to German hose. *Part numbers ending in an E are reproductions of Weber Carb Kits by Empi.
Type 3: 1600
No customer reviews for the moment.
Part #: 1129505115
These are some of the most common jets used. Sold in Pairs
Application:Part #: 1129199055
Accelerator Pump Jets for 40/44 HPMX (EMPI), 40-48 IDF (Weber) 0.55
Application:Part #: 1129512
Empi Hex Bar Linkage for 48/51 EPC and 48 IDA (works with and without Air Cleaners)
Application:Part #: 1129201300
EPC 48/51 3.0 Needle and Seat IDA 300
Application:Part #: 1129305040
These are some of the most common jets used. Sold in pairs.
Application:Part #: 11295076IDF
6" Chrome Velocity Stacks, Pair
Application:Part #: 113129415B
Here are some of the replacement parts for your stock carburetor. Sold individually.
Application:Part #: 1129505
Empi 40/44/48 IDF & HMPX Extended Emulsion Tube Holder
Application:Part #: 112950506IDF
Throttle Shaft Nut for 40/44 HPMX (EMPI), 40-48 IDF (Weber)
Application:Part #: 112950508IDA
Auxiliary Venturi
Application:Part #: 112950501IDF
Mixture Screw for 40/44 HPMX (EMPI), 40-48 IDF (Weber)
Application:Part #: 1129039E
Empi Dual 40mm Carburetor complete setup
Application:Part #: 3129510A
1 3/4" EPC/ICT Type 3 and 4 Hexrod Assembly Linkage
Application:Part #: 1129506IDF
Velocity Stack Covers, for IDF & HPMX Carbs, Pair Fits carbs with velocity stacks & no air cleaners
Application:Part #: 1129026
34 Pict Carburetor spacer plate, measures 3/8" thick with 2 11/16" hole to hole
Application:Part #: 112950505IDA
Stack Hold Down Tab
Application:
We have found this kit to be a good, cheap dual carb kit for a stock motor.
