Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This kit contains most of the seals and gaskets necessary to rebuild an engine. You'll also need to purchase a flywheel seal. If your case is a dual relief motor, you'll also need another copper o-ring for the second relief plug and two more of the oil cooler seals. Note: We use a sealer called Gasgacinch on all our gaskets.
Bus (Type 2): All
No customer reviews for the moment.
Part #: 071198009
This kit contains most of the seals and gaskets necessary to rebuild an engine.
Application:Part #: N122412
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 111101191
25/36 HP Engine Case/ Generator Gasket
Application:Part #: 040101149
Oil pick up Pipe
Application:Part #: 1115139
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: 021198009B
This kit contains most of the seals and gaskets necessary to rebuild an engine.
Application:Part #: 043101025
We only carry NEW dual relief cases. Limited supply!
Application:Part #: 113105245FRS
Rear Main Seal, Double Lipped
Application:Part #: 111199101
These are the bolts that hold the engine in.
Application:Part #: N110104
Some of the more common nuts you might need..
Application:Part #: 1198036
If you are converting a single port engine to a dual port or if you have a brand new case; these are the head studs you're looking for.
Application:Part #: 113101211G
It's possible to put a generator on an alternator stand but not the other way around.
Application:Part #: 1101146
These cheater studs replace the head studs that have pulled from the case.
Application:Part #: 111198005
This kit contains most of the seals and gaskets necessary to rebuild an engine.
Application:Part #: 1101030
Included in this kit are the bolts, nuts and washers required for "out to head" assembly of the engine..
Application:
