Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N109052
Screws for replacement pop out window frames. These screws are for joining the two Popout frame halves together
Application:
This kit contains most of the seals and gaskets necessary to rebuild an engine.
This kit contains most of the seals and gaskets necessary to rebuild an engine. You'll also need to purchase a flywheel seal. If your case is a dual relief motor, you'll also need another copper o-ring for the second relief plug and two more of the oil cooler seals. Note: We use a sealer called Gasgacinch on all our gaskets. For 1800-2000cc engines
Bus (Type 2): 75-78
No customer reviews for the moment.
Part #: 1115139
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: 113198033
We only carry new dual relief cases.
Application:Part #: 1101031
Included in this kit are the bolts, nuts and washers required for "out to head" assembly of the engine..
Application:Part #: 113105245FRS
Rear Main Seal, Double Lipped
Application:Part #: 113101157C
This plug goes in the back of the case (flywheel side).
Application:Part #: 1101030
Included in this kit are the bolts, nuts and washers required for "out to head" assembly of the engine..
Application:Part #: 025198009A
This kit contains most of the seals and gaskets necessary to rebuild an engine.
Application:Part #: 071198009
This kit contains most of the seals and gaskets necessary to rebuild an engine.
Application:Part #: 111199102
This nut came on all dual relief cases.
Application:Part #: 040101149
Oil pick up Pipe
Application:Part #: 1101131
A case saver is an insert that repairs worn or stripped head stud holes in a case.
Application:Part #: N115244
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 111198003
This kit contains most of the seals and gaskets necessary to rebuild an engine.
Application:Part #: 043101129
This is the washer used under the nuts on cases that use an o-ring on the center main studs.
Application:Part #: 1101461KIT
This kit has the correct studs for a dual port engine to hold the heads on. 10mm
Application:Part #: 1101146
These cheater studs replace the head studs that have pulled from the case.
Application:
This kit contains most of the seals and gaskets necessary to rebuild an engine.
