Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N141212
These are the latches that hold the popout frame out.
Application:A case saver is an insert that repairs worn or stripped head stud holes in a case.
A case saver is an insert that repairs worn or stripped head stud holes in a case. They prevent head studs from pulling under normal use. If you don't already have case savers, you should think about having them installed. 16 are required.
Bug (Type 1): All
Bus (Type 2): -71
Type 3: All
Ghia: All
Thing: All
Race/Off-Road: All
No customer reviews for the moment.
Part #: 1115139
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: 111199101
These are the bolts that hold the engine in.
Application:Part #: 111198007AF
This kit contains most of the seals and gaskets necessary to rebuild an engine.
Application:Part #: N110062
Some of the more common nuts you might need..
Application:Part #: 1198036
If you are converting a single port engine to a dual port or if you have a brand new case; these are the head studs you're looking for.
Application:Part #: 113198033
We only carry new dual relief cases.
Application:Part #: N122412
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: N110085
Some of the more common nuts you might need..
Application:Part #: 111101123
These pins position the main bearings in the case halves so you can line up the oil galley holes with the main bearings.
Application:Part #: 113101221B
It's possible to put a generator on an alternator stand but not the other way around.
Application:Part #: N110104
Some of the more common nuts you might need..
Application:Part #: 1101031
Included in this kit are the bolts, nuts and washers required for "out to head" assembly of the engine..
Application:Part #: 1101131
A case saver is an insert that repairs worn or stripped head stud holes in a case.
Application: