Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This crankshaft is made of E4340 chromoly forging, one of the strongest metals known to man.
This crankshaft is made of E4340 chromoly forging, one of the strongest metals known to man. These cranks are fully balanced, magnafluxed and micro-polished. Machine work to the case will be required. It has been our experience that if you are going to run an 82mm stroke crank you should run longer rods that are 5.5" in length.
No customer reviews for the moment.
Part #: 1903108BLU
EMPI Serpentine Belt System Blue
Application:Part #: 113105281A
These shims set the endplay of the crankshaft.
Application:Part #: 1105251CH
This is a stock pulley that has been chromed.
Application:Part #: 113105281A
These shims set the endplay of the crankshaft.
Application:Part #: 1105305
This washer is larger in diameter than stock so it gives you more surface coverage over the dowel pins.
Application:Part #: 113105245FS
This seal goes behind the flywheel.
Application:Part #: 111105433
Wrist Pin Bushing.
Application:Bug (Type 1); 40hp
Bus (Type 2); 40hp
KG; 40hp
Part #: 1105255BK
This is a very nice pulley; the numbers are etched in and do not wear off.
Application:Part #: 1105271
If your are going to run a 69mm or a 78 mm counterweighted crank, then you will want to have your flywheel 8 doweled or get a flywheel has been 8 doweled.
Application:Part #: 113105241A
This is a large concave washer that goes on the crank after you have the nose bearing on.
Application:Part #: 111105305E
It's really a bolt, but that's what everybody calls it.
Application:Part #: 111105233
This gear matches up with the brass gear that is on the crank.
Application:Part #: 111105235A
These are the shims that set the endplay of the distributor drive gear.
Application:Part #: 1105253BK
This is a crank pulley for an upright motor.
Application:Part #: 1105297
This washer is larger in diameter than stock so it gives you more surface coverage over the dowel pins.
Application:Part #: 113105231B
This gear matches up with the brass gear that is on the crank.
Application:
This crankshaft is made of E4340 chromoly forging, one of the strongest metals known to man.
