Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:This brass gear goes on the crank to turn the distributor drive shaft.
This brass gear goes on the crank to turn the distributor drive shaft. When putting on a used gear, make sure that the gear is not deformed. Note: When putting the gear on we use a propane torch like we did on the cam gear. Both gears should be put on at the same time. Do not overheat or the I.D. may distort.
Bug (Type 1): 46-79
Bus (Type 2): 50-79
Vanagon: 80-91
Type 3: 62-73
Ghia: 56-74
Thing: 73-74
Race/Off-Road: 46-79
No customer reviews for the moment.
Part #: 111105305E
It's really a bolt, but that's what everybody calls it.
Application:Part #: 113105281A
These shims set the endplay of the crankshaft.
Application:Part #: 311105101F10
These are used cranks with reground rod and main journals.
Application:Part #: 113105277
These pins hold the flywheel in place on the crankshaft.
Application:Part #: 1105305
This washer is larger in diameter than stock so it gives you more surface coverage over the dowel pins.
Application:Part #: 111105213
This key goes into the crank to align the steel cam gear with the brass distributor drive gear.
Application:Part #: 1105305R
This is a large thrust surfaced gland nut made out of chromoly.
Application:Part #: 1105271
If your are going to run a 69mm or a 78 mm counterweighted crank, then you will want to have your flywheel 8 doweled or get a flywheel has been 8 doweled.
Application:Part #: 111105401EMP
New Connecting Rods, 13-1600cc, Set of 4
Application:Part #: 1105174
This crankshaft is made of E4340 chromoly forging, one of the strongest metals known to man.
Application:Part #: 1105178
This crankshaft is made of E4340 chromoly forging, one of the strongest metals known to man.
Application:Part #: 311105101B10
These are used cranks with reground rod and main journals.
Application:Part #: 311105273AN
VW Flywheel, 200mm 12 volt 15-1600cc Engines
Application:Part #: 1105258
This is a stock, zinc-plated crankshaft pulley bolt that has a 3/8" drive hole broached into the center.
Application:Part #: 113105249
This key holds the oil deflector in place as well as aligns the front pulley.
Application:Part #: 111105313A
It's really a bolt, but that's what everybody calls it.
Application: