Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:Generators supply the battery with voltage. Rebuilt + Core
Generators supply the battery with voltage. To test a 12v generator, take the wires off the D+ and the DF terminals. Grab a volt meter and hook up the volt meter so the positive lead goes to the D+ and the negative to the DF. Now run a jumper wire from the DF to the D-. Start the car and rev the motor. If the meter pegs, the generator is good and if it doesn't, then it's bad. Now if the meter jumps to lower voltage the generator may need to be polorized. To polorize a generator, make sure the voltage regulator wires are still disconnected. Take off the generator belt. Using a battery with jumper cables, hook up the positive to the D+ and the negative to D-. Now with a jumper wire, go from the DF to the body of the generator. Hold the wire there just long enough to see the generator spin like a motor; no longer, or you will burn up the generator. Some generators are sold on exchange.
Bug (Type 1): 67-73
Bus (Type 2): 67
Ghia: 67-
Thing: 73
Race/Off-Road: 67-
No customer reviews for the moment.
Part #: 111903137D
This is the belt that turns the generator.
Application:Part #: 111903181
Generator Pulley Nut
Application:Part #: 1903184
Nut for Billet Pulley Only
Application:Part #: 113119031A
This is the fan that fits inside of the fan shroud on Bugs 1971-1979 and a 1971 Bus.
Application:Part #: 1903109CH
This is a stock generator pulley that has been chromed.
Application:Part #: GR15NCH
Generators supply the battery with voltage. CHINA
Application:Part #: 042903109AGR
VW Generator Pulley, 6V
Application:Part #: 1903532
This is just a cover that fits around a 30amp generator to give it that chrome look.
Application:Part #: GR11X
Generators supply the battery with voltage.
Application:Part #: JC86000
Jaycee Billet Alternator Pulley, Blue
Application:Part #: 111119131
Fan Hub Washer
Application:Part #: 1903531
On all upright motor, this plastic cover goes over the top opening of the generator to keep dirt out.
Application:Part #: 1903137
Replacement belt for Serpentine belt driven Alternator or Generator
Application:Bug (Type 1); 40-1600
Bus (Type 2); 40-1600
KG; 40-1600
Thing; All
Offroad; 40-1600
Part #: AL82NC
This unit supplies the battery with voltage.
Application:Part #: 1301103
This bushing is made to mate mismatched bellhousing and starter combinations.
Application:Part #: 1903109POL
Polished Billet Alternator/Generator Pulley Kit
Application: