Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is what starts the car.
This is what starts the car. It usually quits the furthest place from home. To bench test a starter is tough, as they can work but are weak. In other words, it will work on the bench, but as soon as it has the drag of the engine on it, it won't. The way we test starters is in the car with a remote starter button (a push button with two long wires). Disconnect the battery. Hook up one of the wires to the big post that the battery cable is hooked to and the other wire to where the push-on wire is located. Now connect the battery back up and make sure the E-brake is on and the car is out of gear. Push the remote starter button. If the engine turns over the starter is good, and if it doesn't, it's bad. If you find the starter works with the remote starter but not with the key, call us. You might need a hard start relay or a new electrical part in the ignition switch. Some starters are sold on exchange.
Bug (Type 1): 67-
Bus (Type 2): 67-75
Type 3: 67-
Ghia: 67-
Thing: 73-74
Race/Off-Road: 67-
No customer reviews for the moment.
Part #: 042903109ABR
This is the pulley on the generator that holds the belt.
Application:Part #: 1903109SHIM
Billet Alternator/Generator Pulley Shim Kit (Pack of 5)
Application:Part #: 1903141B
This strap is much stronger than the stock strap, not that you need a super strap to hold the alternator or generator.
Application:Part #: 111903137D
This is the belt that turns the generator.
Application:Part #: 1301104
This bushing is made to mate mismatched bellhousing and starter combinations.
Application:Part #: 111119131
Fan Hub Washer
Application:Part #: 111903515A
These are the bearings and brushes for your generator.
Application:Part #: SRHT6V
A 6volt gear that fits the high torque starter.
Application:Part #: N127051
This is the pulley on the generator that holds the belt.
Application:Part #: 1301103
This bushing is made to mate mismatched bellhousing and starter combinations.
Application:Part #: 1119031BHD
Motors with high horsepower and motors that rev fast run the risk of exploding a stock fan.
Application:Part #: GR11XCO
Generators supply the battery with voltage.
Application:Part #: 113119031B
This is the fan that fits inside of the fan shroud on Bugs 1971-1979 and a 1971 Bus.
Application:Part #: SR17X
This is what starts the car.
Application:Part #: 1903109BIL
Billet Aluminum Pulley - 12 volt alt/gen
Application:Part #: 1903184
Nut for Billet Pulley Only
Application:
This is what starts the car.
