Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is what starts the car.
This is what starts the car. It usually quits the furthest place from home. To bench test a starter is tough, as they can work but are weak. In other words, it will work on the bench, but as soon as it has the drag of the engine on it, it won't. The way we test starters is in the car with a remote starter button (a push button with two long wires). Disconnect the battery. Hook up one of the wires to the big post that the battery cable is hooked to and the other wire to where the push-on wire is located. Now connect the battery back up and make sure the E-brake is on and the car is out of gear. Push the remote starter button. If the engine turns over the starter is good, and if it doesn't, it's bad. If you find the starter works with the remote starter but not with the key, call us. You might need a hard start relay or a new electrical part in the ignition switch. Some starters are sold on exchange.
Bug (Type 1): -66
Bus (Type 2): -66
Type 3: -66
Ghia: -66
Race/Off-Road: -66
No customer reviews for the moment.
Part #: 111903221A
These are the bearings and brushes for your generator.
Application:Part #: JC86030
Jaycee Billet Alternator Pulley, Silver
Application:Part #: GR15XCO
Core Charge Generators supply the battery with voltage. Rebuilt
Application:Part #: 113119031B
This is the fan that fits inside of the fan shroud on Bugs 1971-1979 and a 1971 Bus.
Application:Part #: SR15HT
This is what starts the car.
Application:Part #: SR11XCO
This is what starts the car.
Application:Part #: 111119123A
Cooling Fan Hub
Application:Part #: SRHT6V
A 6volt gear that fits the high torque starter.
Application:Part #: JC86020
Jaycee Billet Alternator Pulley, Red
Application:Part #: 111119270B
This is a hub that is keyed onto the generator or alternator to mount the fan.
Application:Part #: SR17X
This is what starts the car.
Application:Part #: 113903141B
The generator strap goes around the generator and holds the generator to the stand..
Application:Part #: 1903531
On all upright motor, this plastic cover goes over the top opening of the generator to keep dirt out.
Application:Part #: 113971901A
This boot goes over the wire and the terminal of the generator or alternator.
Application:Part #: 1903184
Nut for Billet Pulley Only
Application:Part #: 1903141
This chrome strap holds the alternator or generator to the stand.
Application:
This is what starts the car.