Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
When you mount the middle seat, you'll want the rubber mat down and the bolts in the key slots first.
When you mount the middle seat, you'll want the rubber mat down and the bolts in the key slots first. Then place the mounting plates into the holes of the mat. Now place the seat on the plates and slide the hooks over the bolts and thread the nuts down and tighten them. The rear seat doesn't sit on a mat so you don't use the mounting plates, just the hooks and nuts. 6 Required
Bus (Type 2): 55-67
No customer reviews for the moment.
Part #: 111881281
When you mount the middle seat, you'll want the rubber mat down and the bolts in the key slots first.
Application:Part #: 221883861A
When you mount the middle seat, you'll want the rubber mat down and the bolts in the key slots first.
Application:Part #: 111881285
When you mount the middle seat, you'll want the rubber mat down and the bolts in the key slots first.
Application:Part #: 111827331A
Engine Deck Lid Spring
Application:Part #: 211957801F
This cable goes from the speedo to the driver side front wheel.
Application:Part #: 1101461KIT
This kit has the correct studs for a dual port engine to hold the heads on. 10mm
Application:Part #: 151863123
These are the interior panels.
Application:Part #: 4885401CU
Like the custom door panels these car seat covers are a great way to customize the interior of your Bug.
Application:Part #: 141943131
This is the lens and seal for the light that shines on the license plate.
Application:Part #: 251711629
Heater cables open the flaps in the heater boxes allowing heat into the car.
Application:Part #: 211809101B
This is what everyone cut out in the 60's.
Application:Part #: 151857641CGY
Also known as the "oh shit" handle.
Application:Part #: 039256092C
Heater Box T2 Right Non-CA
Application:Part #: 6B03010WH
These boots are made to keep water and dirt out of distributor and coil.
Application:Part #: 6821305N
These kits are really thick and have a great fitting hood.
Application:Part #: 211857223A
Bare Metal Finish Radio Block off Plate
Application:Part #: 211609638A
Clamp for E-Brake to Backing Plate, Right
Application:Part #: 211941037C
Headlight Assembly, US Style, Clear Glass, Complete less bulbs, LEFT
Application:
When you mount the middle seat, you'll want the rubber mat down and the bolts in the key slots first.
