Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
When you mount the middle seat, you'll want the rubber mat down and the bolts in the key slots first.
When you mount the middle seat of a bus, you'll want the rubber mat down and the bolts in the key slots first. Then place the mounting plates into the holes of the mat. Now place the seat on the plates and slide the hooks over the bolts and thread the nuts down and tighten them. To use on pre -67 Buses and -55 Bugs you will need to grind nipple off of the inside of clamp.
No customer reviews for the moment.
Part #: N161371
When you mount the middle seat, you'll want the rubber mat down and the bolts in the key slots first.
Application:Part #: 111881281
When you mount the middle seat, you'll want the rubber mat down and the bolts in the key slots first.
Application:Part #: 221883861A
When you mount the middle seat, you'll want the rubber mat down and the bolts in the key slots first.
Application:Part #: 211707300
Splash Pan Reinforcement Plates, Set of 2
Application:Part #: 1501607
We make wheel adapters for some of the more common drums and wheels.
Application:Part #: 6012903L
This pole has a light on the top of it, just above the flag.
Application:Part #: 241845421
This seal goes around the corner window of buses up to 1963.
Application:Part #: 2847105APL
New replacement pop out window frames in polished stainless steel. They look like chrome but wont rust.
Application:Bus (Type 2); 50-67
Part #: 211829233
Rear Hatch Button Seal
Application:Part #: 211615107CO
Front calipers hold the brake pads that stop the rotor, which in turn stops your vehicle.
Application:Part #: 113853559A
These are the clips that hold the various chrome moldings on.
Application:Part #: 6801102
These tabs are used for mounting just about anything to tubing..
Application:Part #: 211809258
"B" Post Outer Repair Section, Right 400mm (15.75")
Application:Part #: 261801804S
Inner Post For Side Panel, Lower 220mm
Application:Part #: 211817000
Overhead Fresh Air Vent Hardware Kit
Application:Part #: 141881402
Like the door panels, seat covers are a long subject; so here's the basics.
Application:
When you mount the middle seat, you'll want the rubber mat down and the bolts in the key slots first.
