Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
We have found this kit to be a good, cheap dual carb kit for a stock motor. Throttle bushings wearing out over time is the only bad thing we can say about them. We suggest you change the fuel hose in the kit to German hose. *Part numbers ending in an E are reproductions of Weber Carb Kits by Empi.
Bus (Type 2): 1700-2000
No customer reviews for the moment.
Part #: 1129611
This is a good, cheap dual carburetor kit for a 1600cc motor.
Application:Part #: 1127022
This block off is used in conjunction with electric fuel pumps and mounts in place of the manual fuel pump.
Application:Part #: 1129700
This is a good, cheap dual carburetor kit for a 1600cc motor.
Application:Part #: 1127110
This is a brass tee for dual carbs.
Application:Part #: VCP12
This is a rubber plug that is used to plug off vacuum.
Application:Part #: 1129729RD
These boots are better than stock.
Application:Part #: 2129707
These gaskets are for upright dual port engines.
Application:Part #: 022129707F
The Intake Manifold Gasket (2 are required per engine).
Application:Part #: 113129717LRG
Dual Port Gaskets without Pin Holes
Application:Part #: 113127025G
These stock pumps pump fuel into the carburetor.
Application:Part #: 021129707D
These are the gaskets used between the intake manifold and the cylinder head.
Application:Part #: 1129709
This pair of aluminum end castings are for use with a center section manifold.
Application:Part #: 113127521AWG
This metal line goes from the pump around the fan shroud to the flex line that comes from the gas tank.
Application:Part #: 113127311
These stock pumps pump fuel into the carburetor.
Application:Part #: 1129604
This air cleaner takes the place of a stock air cleaner.
Application:Part #: 1129809K
Kadron Air Cleaner Base Gasket (Pair)
Application: