Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
It caps the hole you are aiming at while pouring oil over everything else. Used ones are fine as long as the gasket is good.
Bug (Type 1): 75-
Bus (Type 2): 1700-1800
No customer reviews for the moment.
Part #: 1115455
The smooth flow design has a nice look and comes with a knurled cross-groove or smooth billet grooved cap for a good grip when it is wet or oily.
Application:Part #: N122412
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 1117098
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: 1117011
These bolt on mounts allow you to bolt the filter adapter under the driver's side fender or hang it off the exhaust flange..
Application:Part #: 1117105ALM
These fittings are used for the stainless steel hose.
Application:Part #: 1117024
Mesa coolers are the state of the art oil coolers.
Application:Part #: 1115181
A stock sump plate that has been chromed..
Application:Part #: 1117007
This is the high-temp/pressure hose used for routing oil to coolers and filters.
Application:Part #: 1117109B
Billett Oil Cooler Block Off
Application:Part #: 1117699
When mounting the oil cooler above the transmission on a Bug, Type 3, Ghia, Thing, or Off Road car you can use these rubber mounted studs.
Application:Part #: 2117004
This adapter is used to mount an oil filter either by itself or in line with an oil cooler.
Application:Part #: 1117101
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: 1115183BL
This plate is made out of a solid piece of aluminum. Blue
Application:Part #: 1115610BL
Billet Dipstick, Blue
Application:Part #: N110085
Some of the more common nuts you might need..
Application:Part #: 111115485
It caps the hole you are aiming at while pouring oil over everything else.
Application:
