Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This stock oil cooler cools the hot oil coming from the engine.
This stock oil cooler cools the hot oil coming from the engine. We recommend the doghouse style over the earlier one because the hot air exits the cooler and goes outside the engine compartment. The earlier cooler allows the hot air to go over the #3&4 cylinders, an inadequate way of cooling. Note: When installing the fan shroud over the doghouse cooler you should wrap a piece of foam over the top of the cooler to insure that air from the fan goes through the cooler and not around it. When it comes to oil cooler seals, we suggest you give us a call.
Bug (Type 1): 46-70
Bus (Type 2): 50-70
Type 3: 62
Ghia: 56-70
Race/Off-Road: 46-70
No customer reviews for the moment.
Part #: N122412
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 1115420
This is one way to adjust your oil pressure.
Application:Part #: 1117106
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: 1115105E
Oil Pick Up Tube Cut To Length
Application:Part #: N110623
Some of the more common nuts you might need..
Application:Part #: JC22270
Jaycee Billet Oil Cap with Breater -10 AN Fitting, Blue
Application:Part #: 1115141
This oil pump cover comes with a threaded boss.
Application:Part #: 1115455
The smooth flow design has a nice look and comes with a knurled cross-groove or smooth billet grooved cap for a good grip when it is wet or oily.
Application:Part #: 1115610BK
Billet Dipstick, Black
Application:Part #: 1115453
This stock oil filler and cap has been chromed.
Application:Part #: 1115450PL
The oil filler extension screws into the generator stand and comes with a fitting to vent the crankcase.
Application:Part #: 1115351
This is the last oil filter you will ever buy.
Application:Part #: 1117101
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: 1115107AFF
26mm Oil pump for dual relief case with a flat cam. For full flowed motors only.
Application:Part #: 1117101ALF
These fittings are used for the stainless steel hose.
Application:Part #: 021115311
It caps the hole you are aiming at while pouring oil over everything else.
Application:
This stock oil cooler cools the hot oil coming from the engine.
