Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This air filter is made to protect the crankcase.
This air filter is made to protect the crankcase. Air that builds up in the case is let out of the filter, while keeping dirt from entering the case. Remember dirt can be damaging and shortens the life of your motor. We use a hose to connect the air filter to the tube coming out of the oil filler. The hose should go around the fan shroud on the number #1-2 side and through the tin, so that the filter is next to the heater box. We prefer this setup to running oily air down the carburetor(s)on street cars. On off road cars we run a hose up high above the engine.
Bug (Type 1): All
Bus (Type 2): All
Type 3: All
Ghia: All
Thing: All
Race/Off-Road: All
No customer reviews for the moment.
Part #: 111115450
Vapor Baffle 25-36 HP
Application:Part #: 1117007SS
This is the high-temp/pressure hose wrapped with braided stainless steel.
Application:Part #: 1129614F
This fitting can be used when routing your breather hose into your air cleaner.
Application:Part #: 113115611
No, this isn't that distant cousin.
Application:Part #: 1117111
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: 1115455
The smooth flow design has a nice look and comes with a knurled cross-groove or smooth billet grooved cap for a good grip when it is wet or oily.
Application:Part #: 1115485CH
A stock cap that has been chromed for looks..
Application:Part #: 111115475A
Oil Filler Seal, 25-36 HP
Application:Part #: 1115457
The smooth flow design has a nice look and comes with a knurled cross-groove or smooth billet grooved cap for a good grip when it is wet or oily.
Application:Part #: 1115610RD
Billet Dipstick, Red
Application:Part #: JC21030
Jaycee Mag-Plate, 6 Bolt, Blue
Application:Part #: 113117321
Hoover Bit, Oil Cooler Sealing Frame
Application:Part #: 1117109
This block off plate is made to loop the oil back into the case in place of the stock oil cooler.
Application:Part #: 1115449OIL
Replacement Oil Cap Billet "OIL"
Application:Part #: 1115182
A stock sump plate that has been chromed..
Application:Part #: 1115467
This is a breather box that will give excess "blow by" a place to go.
Application:
This air filter is made to protect the crankcase.
