Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Whether your motor lives or not can depend upon this little shim.
Whether your motor lives or not can depend upon this little shim. Many people tend to overlook this part, but the shim controls the compression ratio. Compression equals heat and heat destroys motors. Take the time to figure your compression ratio and get the proper shims for that desired compression. Figuring compression ratios and getting the right shims is a long subject, so for help, just call. We find that 99.9% of all engines need barrel shims. Shims are sold in sets of 4.
No customer reviews for the moment.
Part #: 1198087
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 1109398
These rocker studs are much stronger than the stock studs and are .100" longer to allow more flexibility when setting your rocker arm geometry..
Application:Part #: 111101481
This gasket goes between the valve cover and the head.
Application:Part #: 113101353ERB
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld). Due to a shortage of cores we will need your Cylinder head Cores before sending any Rebuilt heads.
Application:Part #: 1101448
This is a shim that is used between the head and barrel.
Application:Part #: 1101474
These covers look good but have a tendency to leak.
Application:Part #: 1101472
If you like clip on valve covers these are the best that we have seen.
Application:Part #: 1101476BWG
Wolfgang Billet Valve Covers There are a few companys making billet valve covers and I have used a few of them and liked them. But we decided to make our own with a few differences.
Application:Part #: 1198094C
94mm Mahle Barrels
Application:Part #: 1198162A
These rings are cast iron.
Application:Part #: 1198090A
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 311198069F
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 11310140105
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1101473OR
These covers look good but have a tendency to leak.
Part #: 1101440
This is a shim that is used between the head and barrel.
Application:Part #: 1101344
36 HP Barrel Shims .040 (4)
Application:
Whether your motor lives or not can depend upon this little shim.
