Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Whether your motor lives or not can depend upon this little shim.
Whether your motor lives or not can depend upon this little shim. Many people tend to overlook this part, but the shim controls the compression ratio. Compression equals heat and heat destroys motors. Take the time to figure your compression ratio and get the proper shims for that desired compression. Figuring compression ratios and getting the right shims is a long subject, so for help, just call. We find that 99.9% of all engines need barrel shims. Shims are sold in sets of 4.
Bug (Type 1): 1600
Ghia: 1600
Race/Off-Road: 1600
No customer reviews for the moment.
Part #: 111198157BBB
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: N14402140
Some of the most common studs you might need. Stud 8mm x 40mm
Application:Part #: 1198083
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 1101441
This is a shim that is used between the head and barrel.
Application:Part #: 1198160
These rings are cast iron.
Application:Part #: 1101475BL
These are just stock valve covers that are chrome.
Application:Part #: 113101481F
This gasket goes between the valve cover and the head.
Application:Part #: 1101351
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1109398
These rocker studs are much stronger than the stock studs and are .100" longer to allow more flexibility when setting your rocker arm geometry..
Application:Part #: 111101401B02
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: N110085
Some of the more common nuts you might need..
Application:Part #: 1101469
If you have high compression you will need to vent the valve covers into a breather box. Deluxe Vents have barbed end for the hose connection.
Application:Part #: 1101352
.
Application:Part #: 1109513
Valve seats are used in the big valve heads.
Application:Part #: 311198069MF
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers. MAHLE FORGED
Application:Part #: 1101472
If you like clip on valve covers these are the best that we have seen.
Application:
Whether your motor lives or not can depend upon this little shim.