Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
If you're rebuilding your own heads, you will probably need guides.
If you're rebuilding your own heads, you will probably need guides. Oversize guides refer to the outer diameter. Note: When installing, heat the head and freeze the guide; they will go in easier. We advise you not to try this yourself unless you have experience in replacing guides.
No customer reviews for the moment.
Part #: 1101448
This is a shim that is used between the head and barrel.
Application:Part #: 11310140102
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1101446
This is a shim that is used between the head and barrel.
Application:Part #: 1198094C
94mm Mahle Barrels
Application:Part #: 1198092A
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 1101468
If you have high compression you will need to vent the valve covers into a breather box.
Application:Part #: 1198087
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 315198163A
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 1198159B
These rings are cast iron.
Application:Part #: 111109623
25/36 HP Valve Springs (Set of 8)
Application:Part #: 1101355P
Here's another long subject, but it'll give you a little something to think about.
Application:Part #: 111198057
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 311101353ACO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 043101457
These nuts and washers hold the heads on.
Application:Part #: N110085
Some of the more common nuts you might need..
Application:Part #: 1101442
This is a shim that is used between the head and barrel.
Application:
If you're rebuilding your own heads, you will probably need guides.
