Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These nuts and washers hold the heads on.
These nuts and washers hold the heads on. The washers are thick so they won't deform under heat and torque. The torque on 10mm nuts is 28 ft. lb. and the 8mm nuts is 18 ft.lb. One trick is to use 3M glue on the bottom of the washers in the rocker area to prevent leaking through the head.
Bug (Type 1): All
Bus (Type 2): All
Type 3: All
Ghia: All
Thing: All
Race/Off-Road: All
No customer reviews for the moment.
Part #: 1198163ATS
94mm Piston Rings Total Seal
Application:Part #: 1101384
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1198094BWVP
Wiseco 94mm with Valve Pockets Pistons & Cylinders
Application:Part #: 1101482EMP
This is the replacement mounting hardware kit for Channel Gasket Style Valve Covers.
Application:Part #: 1101374
40 HP Barrel Shims .040 (4)
Application:Part #: 1101484
This is like a stock gasket except it is made out of rubber instead of cork.
Application:Part #: 1198092BWCH
92mm Pistons & Cylinders Thick Wall set with a 82mm Stroke CHINA
Application:Part #: 1109398
These rocker studs are much stronger than the stock studs and are .100" longer to allow more flexibility when setting your rocker arm geometry..
Application:Part #: 1101396
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 111101401B02
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1101462KIT
This kit has the correct nuts and washers to hold the heads on the engine..
Application:Part #: 311198069FM
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers. MAHLE
Application:Part #: 1198087
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 113101481F
This gasket goes between the valve cover and the head.
Application:Part #: 1101477BL
These covers look good but have a tendency to leak.
Application:Part #: 1101473OR
These covers look good but have a tendency to leak.
These nuts and washers hold the heads on.
