Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
All kits come with pistons, cylinders, rings, wrist pins and clips.
All kits come with pistons, cylinders, rings, wrist pins and clips. Many of the kits will require machine work to the heads and case. Before you buy a kit, you should have a good understanding of how to set the compression ratio. Many people think that bigger motors are unreliable. This is just not true. When a motor is properly designed and built, it can be very dependable. You will not realize the full potential of the bigger pistons, unless you run big valve heads. There is a lot of information needed, so call us and we will gladly help. Note: The only thing we don't like about these kits are the rings and the wrist pin clips.
No customer reviews for the moment.
Part #: 1109604
Valve seats are used in the big valve heads.
Application:Part #: 111101481
This gasket goes between the valve cover and the head.
Application:Part #: 111198157BBB
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 1198163
These rings are cast iron.
Application:Part #: 1101384
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1109512
Valve seats are used in the big valve heads.
Application:Part #: 1101476BWG
Wolfgang Billet Valve Covers There are a few companys making billet valve covers and I have used a few of them and liked them. But we decided to make our own with a few differences.
Application:Part #: 311198169A
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 311101353ACO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 1101440
This is a shim that is used between the head and barrel.
Application:Part #: 1109602
Valve seats are used in the big valve heads.
Application:Part #: 1198159
These rings are cast iron.
Application:Part #: 1101476
These are great valve covers.
Application:Part #: 1101441
This is a shim that is used between the head and barrel.
Application:Part #: N14402140
Some of the most common studs you might need. Stud 8mm x 40mm
Application:Part #: 1101446
This is a shim that is used between the head and barrel.
Application:
All kits come with pistons, cylinders, rings, wrist pins and clips.
