Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
There are two types of keepers we like to use.
There are two types of keepers we like to use. One is a spiral lock keeper, which locks by overlapping itself. The other keeper is a Tru-Arc clip, which is a clip that has a aquare edge instead of a wire round edge. We highly recommend using either one of these keepers. It's cheap insurance against losing a clip and scarring your cylinder.
No customer reviews for the moment.
Part #: 113101353ECO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 111198057
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 1198163ATS
94mm Piston Rings Total Seal
Application:Part #: 1198094A
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 1198161TS
90.5mm Piston Rings 1.5x2x4 Total Seal
Application:Part #: 1101357
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1101389
Whether your motor lives or not can depend upon this little shim.
Application:Part #: N14402140
Some of the most common studs you might need. Stud 8mm x 40mm
Application:Part #: 1198092ACH
92mm Pistons & Cylinders set with a 69mm Stroke CHINA
Application:Part #: 113101353BCO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 1109512
Valve seats are used in the big valve heads.
Application:Part #: N110085
Some of the more common nuts you might need..
Application:Part #: 1101393
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1101353
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1101472
If you like clip on valve covers these are the best that we have seen.
Application:Part #: 111101401B
If you're rebuilding your own heads, you will probably need guides.
Application:
There are two types of keepers we like to use.
