Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These are also known as the "forget-me-nots".
These are also known as the "forget-me-nots". When putting on your barrels, place the deflectors next to the barrels. Clip them into place before putting the heads on. If you "forget" them, take the heads back off and put them on. They are important for cooling, as they deflect air around the bottom of the barrels.
Bug (Type 1): 1500-1600
Bus (Type 2): 1500-1600
Type 3: 1500-1600
Ghia: 1500-1600
Thing (Type 5): 1500-1600
Race/Off-Road: 1500-1600
No customer reviews for the moment.
Part #: 1119517BK
This piece of tin goes behid the engine towards the flywheel and screws down to the cylinder tins.
Application:Part #: 1119527CH
This tin goes from one piece of cylinder tin to the other.
Application:Part #: 1119100
These plugs fit into the fan shroud, plugging off the heater ducts.
Application:Part #: 1119026CH
This style fan shroud combines the small shroud of the 36hp and the later doghouse style shroud.
Application:Part #: 1119533CH
This tin goes behind the crank pulley.
Application:Part #: 043119352
Heater Channel Tin Lower Right
Application:Part #: 1119528CH
This tin goes from one piece of cylinder tin to the other.
Application:Part #: 043119350B
Heater Channel Tin Upper Right
Application:Part #: 1119027BK
This small fan shroud came on the 36hp motor.
Application:Part #: 1119023
This spacer kit uses 1 1/4" thick aluminum spacers to close the gap between the fan shroud and the cylinder tins where the sheet metal screw attaches.
Application:Part #: 1119516BK
This piece of tin goes behid the engine towards the flywheel and screws down to the cylinder tins.
Application:Part #: 1119026BK
This style fan shroud combines the small shroud of the 36hp and the later doghouse style shroud.
Application:Part #: 043119351B
Heater Channel Tin Left
Application:Part #: 113119317
These are also known as the "forget-me-nots".
Application:Part #: 1903031CH
This is one of the three-pieces of the Alternator or Generator Tin Set, it's the large flat plate that is seen.
Application:Part #: 111119571
In the stock front pulley tin, there is a hole for the 1" hose coming down from the stock air cleaner.
Application:
These are also known as the "forget-me-nots".
