Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:This boot goes around the nose cone to seal up the hole where it comes through the pan.
This boot goes around the nose cone to seal up the hole where it comes through the pan. It's a good idea to have this boot as it eliminates a lot of noise and keeps a great deal of dirt, grime, and grease from entering the tunnel. When the transmission is out of the car, just slip it over the nose cone, it's easy to install.
Bug (Type 1): -79
Type 3: 62-73
Ghia: 61-74
Thing: 73-74
Race/Off-Road: All
No customer reviews for the moment.
Part #: 1517122
These diffs add two more spider gears to your differential, plus the housing is way stronger then stock.
Application:Part #: 1311123
This steel thrust plate stops movement of the main shaft bearing and aids in the keepin the alignment of the gears on the main and pinion shafts.
Application:Part #: 1301049
These straps are a good idea if you have a car with a big engine.The rear strap keeps the bell housing from twisting and the front strap keeps the nose of the transmission from breaking the front mount.We highly recomend that you use these in conjunction with the urethane transmission mounts.
Application:Part #: 1301050
These straps are a good idea if you have a car with a big engine.The rear strap keeps the bell housing from twisting and the front strap keeps the nose of the transmission from breaking the front mount.We highly recomend that you use these in conjunction with the urethane transmission mounts.
Application:Part #: 6501141
These retainers help stiffen the plates that bolts the tubes to the trans.
Application:Part #: 111398003
Transmission gasket set.
Application:Bug (Type 1); -60
Bus (Type 2); -59
Ghia; -60
Part #: 113301189F
These are the seals that go around the final drives on an IRS transmission.
Application:Part #: 113311113A
This seal goes around the mainshaft.
Application:Part #: 113713145A
The points that are in the shifter that disengage the transmission..
Application:Part #: 001301083
This seal keeps the fluid in the converter.
Application:Part #: 113301264
These rubber mounts hold the transmission in place.
Application:Part #: 1301051
High performance street cars or off road cars have been known to crack stock transmission cases.
Application:Part #: 113301211G
This is the front of the transmission that houses the shift lever.
Application:Part #: 113301229A
This is the front of the transmission that houses the shift lever.
Application:Part #: 113301265E
These rubber mounts hold the transmission in place.
Application:Part #: 111301289
Nose Cone Boot
Application: