Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
We've had no luck with regrinds, therefore we sell only new camshafts.
We've had no luck with regrinds, therefore we sell only new camshafts. German cams were the best, but are no longer available. These are the best stock grind cams available at this time. Every since Engle has come out with the "90" cam. We don't even sell these cams anymore.
No customer reviews for the moment.
Part #: 11310140108
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 113109612A
The two outside valves in the head are the exhaust valves, they let the burned fuel out of the head.
Application:Part #: 1109401125SC
1.25 Ratio Rockers Pro SCAT
Application:Part #: 111109345
Push Rod tube seal for 36 HP
Application:Part #: 1109305
Aluminum Smith Bros. Push Rods
Application:Part #: 113101399B
Rocker Arm Stud
Application:Part #: 1109310
These lifters are made by Engle and have a small hole in the end of them that allows oil to be pumped onto the cam lobe and lifter face.
Application:Part #: 1109401125
Rocker Arms, High Ratio 1.25, w/Bushing, Set
Application:Part #: 1109006
These gears give just a hair more horsepower.
Application:Part #: 1109398
These rocker studs are much stronger than the stock studs and are .100" longer to allow more flexibility when setting your rocker arm geometry..
Application:Part #: 11310140102
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 11094011
Rocker Arms Kit, HP Stock 1.1
Application:Part #: 113109641B
These springs return the valves back to their seats.
Application:Part #: 1109651
We have had good luck with stock keepers on single springs.
Application:Part #: 1109641
If you are going to run dual springs we suggest you use these valve spring retainers as well.
Application:Part #: 1109430
These shims are used under the rockers to set the geometry.
Application:
We've had no luck with regrinds, therefore we sell only new camshafts.
