Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These shims are used under the rockers to set the geometry.
These shims are used under the rockers to set the geometry. This is a very important step, so if you need help, call and we will be happy to explain it to you. Sold in sets of four.
Bug (Type 1): 40hp-1600
Bus (Type 2): 40hp-1600
Type 3: 40hp-1600
Ghia: 40hp-1600
Thing: 40hp-1600
Race/Off-Road: 40hp-1600
No customer reviews for the moment.
Part #: 1109400
This kit eliminates the clips and spring washers in a rocker shaft set up.
Application:Part #: 1109410
These shims are used with the Solid Shaft Rocker Kit.
Application:Part #: JC91040
Jaycee Leak proof Pushrod Tubes, Silver
Application:Part #: 1109642
If you are going to run dual springs we suggest you use these valve spring retainers as well.
Application:Part #: 043109611A
The two outside valves in the head are the exhaust valves, they let the burned fuel out of the head.
Application:Part #: JC91020
Jaycee Leak proof Pushrod Tubes, Black
Application:Part #: 113109021DBR
We've had no luck with regrinds, therefore we sell only new camshafts.
Application:Part #: 1109002USA
Cam Gear without bolts USA Made
Application:Part #: 1109310
These lifters are made by Engle and have a small hole in the end of them that allows oil to be pumped onto the cam lobe and lifter face.
Application:Part #: 113109641B
These springs return the valves back to their seats.
Application:Part #: 111198541HD
The cam rides in these bearings.
Application:Part #: 1109603
Stainless steel valves are used in the big valve heads.
Application:Part #: 1109006
These gears give just a hair more horsepower.
Application:Part #: 111109345
Push Rod tube seal for 36 HP
Application:Part #: 311109335
These tubes go from the case to the heads to house the push rods.
Application:Part #: 111109325
Push Rod Guide, 25-36 HP, Each
Application:
These shims are used under the rockers to set the geometry.
