Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
If you're rebuilding your own heads, you will probably need guides.
If you're rebuilding your own heads, you will probably need guides. Oversize guides refer to the outer diameter. Note: When installing, heat the head and freeze the guide; they will go in easier. We advise you not to try this yourself unless you have experience in replacing guides.
Bug (Type 1): All
Bus (Type 2): All
Ghia: All
No customer reviews for the moment.
Part #: 1101482
These covers look good but have a tendency to leak.
Application:Part #: 1198094BCH
94mm Pistons & Cylinders set with a 82mm Stroke CHINA
Application:Part #: 070198169
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 1198092BWCH
92mm Pistons & Cylinders Thick Wall set with a 82mm Stroke CHINA
Application:Part #: 021101457
These nuts and washers hold the heads on.
Application:Part #: 1109398
These rocker studs are much stronger than the stock studs and are .100" longer to allow more flexibility when setting your rocker arm geometry..
Application:Part #: 1101474
These covers look good but have a tendency to leak.
Application:Part #: 113101353BCO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 1109604
Valve seats are used in the big valve heads.
Application:Part #: 1198094A
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 1198160
These rings are cast iron.
Application:Part #: 1101399
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1101381
Whether your motor lives or not can depend upon this little shim.
Application:Part #: N122412
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 1101383
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1198162
These rings are cast iron.
Application:
If you're rebuilding your own heads, you will probably need guides.
