Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These caps go on the ends of the valve.
These caps go on the ends of the valve. Use them if you are running stock valve adjusting screws on stainless steel valves or running ratio rockers that don't have a swivel foot set up on the valve end.
No customer reviews for the moment.
Part #: 1109302
These push rods are made out of chromoly steel and do not expand at the same rate as aluminum.
Application:Part #: 1109009
We have had good luck with this cam and prefer it over new stock cams and is a great cam when you want to stay with the stock carburetor or Kadrons.
Application:Part #: 1109651
We have had good luck with stock keepers on single springs.
Application:Part #: 111109345
Push Rod tube seal for 36 HP
Application:Part #: 1109603
Stainless steel valves are used in the big valve heads.
Application:Part #: 1109336
These push rod tubes are spring loaded and are great for replacing bent tubes without having to pull the head(s) off.
Application:Part #: 11310140105
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 111198541GR
The cam rides in these bearings.
Application:Part #: 1109451
This style of adjusting screw has a ball with a flat side on the end.
Application:Part #: 043109451
This screw rides against your valve, opening and closing it.
Application:Part #: 1109398
These rocker studs are much stronger than the stock studs and are .100" longer to allow more flexibility when setting your rocker arm geometry..
Application:Part #: 1109400
This kit eliminates the clips and spring washers in a rocker shaft set up.
Application:Part #: 111101401B
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1109406
These shims are used with the Solid Shaft Rocker Kit.
Application:Part #: 11310140108
If you're rebuilding your own heads, you will probably need guides.
Application:
These caps go on the ends of the valve.
