Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Engle cams are one of the most popular performance camshafts made for the air-cooled Volkswagen.
Engle cams are one of the most popular performance camshafts made for the air-cooled Volkswagen. All shafts are ground from new billet castings and many sizes and profiles are available. The cams listed below are designed for use with stock ratio rockers. Note: Always check for lifter boss clearance. We have many years of experience with performance Bug engines, so please call for advice when choosing a cam. Never use any of these cams with stock carburetion. Engle cams do not come with a gear or bolts. We carry more Engle cams then what is listed here so if you don't see what you are looking call.
Bug (Type 1): 1600
Bus (Type 2): 1600
Type 3: 1600
Ghia: 1600
Thing: 1600
Race/Off-Road: 1600
No customer reviews for the moment.
Part #: 113109335
These tubes go from the case to the heads to house the push rods.
Application:Part #: 113109309C
These ride against the cam. Sold each. You will need 8 to do an engine
Application:Part #: 1109001
Engle cams are one of the most popular performance camshafts made for the air-cooled Volkswagen.
Application:Part #: 1109651
We have had good luck with stock keepers on single springs.
Application:Part #: 1109302
These push rods are made out of chromoly steel and do not expand at the same rate as aluminum.
Application:Part #: 111109601A
Intake Valve 30mm (each)
Application:Part #: JC91010
Jaycee Leak proof Pushrod Tubes, Red
Application:Part #: 1109613
Stainless steel valves are used in the big valve heads.
Application:Part #: 113109021GBR
We've had no luck with regrinds, therefore we sell only new camshafts.
Application:Part #: 111109325
Push Rod Guide, 25-36 HP, Each
Application:Part #: 1109400
This kit eliminates the clips and spring washers in a rocker shaft set up.
Application:Part #: 1109603
Stainless steel valves are used in the big valve heads.
Application:Part #: 043109611A
The two outside valves in the head are the exhaust valves, they let the burned fuel out of the head.
Application:Part #: 1109460
These shims are used under the rockers to set the geometry.
Application:Part #: 1109341OR
Replacement O-Ring Set 16 pieces
Application:Part #: 11310140102
If you're rebuilding your own heads, you will probably need guides.
Application:
Engle cams are one of the most popular performance camshafts made for the air-cooled Volkswagen.