Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These tubes go from the case to the heads to house the push rods.
These tubes go from the case to the heads to house the push rods. They also return the oil from the heads to the case. We highly recommend that you replace these whenever you pull the heads off a 1200 through a 1600 engine. The stock tubes have a crush built into each end. If you try to stretch the old ones, they will go back to where they were crushed as soon as they heat up and more than likely leak. Note: You should be careful putting the seals on. It's real easy to cut your fingers. On Buses 1972 on you do not need to replace the old tubes and they can be installed after the heads are on.
Bus (Type 2): 72-79
Vanagon: 80-83
No customer reviews for the moment.
Part #: 113109612
The two outside valves in the head are the exhaust valves, they let the burned fuel out of the head.
Application:Part #: 1109339
These push rod tubes are spring loaded and are great for replacing bent tubes without having to pull the head(s) off.
Application:Part #: 11094011
Rocker Arms Kit, HP Stock 1.1
Application:Part #: 1109403
These shims are used with the Solid Shaft Rocker Kit.
Application:Part #: 2109001
T4 Camshaft Gear, Bolt On
Application:Part #: 021109111G
Aluminum Cam Gear
Application:Part #: 11310140102
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 113109335
These tubes go from the case to the heads to house the push rods.
Application:Part #: 11310140105
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1109002USA
Cam Gear without bolts USA Made
Application:Part #: 1109603
Stainless steel valves are used in the big valve heads.
Application:Part #: 1109336
These push rod tubes are spring loaded and are great for replacing bent tubes without having to pull the head(s) off.
Application:Part #: 1109623
These are single heavy duty valve springs which are used on engines with Engle 110 or larger cams.
Application:Part #: 1109002
Premium Performance Aftermarket Cam Gear
Application:Part #: 1109305
Aluminum Smith Bros. Push Rods
Application:Part #: 113109612A
The two outside valves in the head are the exhaust valves, they let the burned fuel out of the head.
Application:
These tubes go from the case to the heads to house the push rods.
