Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These tubes go from the case to the heads to house the push rods.
These tubes go from the case to the heads to house the push rods. They also return the oil from the heads to the case. We highly recommend that you replace these whenever you pull the heads off a 1200 through a 1600 engine. The stock tubes have a crush built into each end. If you try to stretch the old ones, they will go back to where they were crushed as soon as they heat up and more than likely leak. Note: You should be careful putting the seals on. It's real easy to cut your fingers. On Buses 1972 on you do not need to replace the old tubes and they can be installed after the heads are on.
Bug (Type 1): 66-79
Bus (Type 2): 63-71
Type 3: 62-73
Ghia: 66-74
Thing: 73-74
Race/Off-Road: 66-79
No customer reviews for the moment.
Part #: 113109623C
These springs return the valves back to their seats.
Application:Part #: 1109612
Stainless steel valves are used in the big valve heads.
Application:Part #: 1109400
This kit eliminates the clips and spring washers in a rocker shaft set up.
Application:Part #: 1109338
These push rod tubes are spring loaded and are great for replacing bent tubes without having to pull the head(s) off.
Application:Part #: 111198541HD
The cam rides in these bearings.
Application:Part #: 111109611A
Exhaust Valve 36 HP
Application:Part #: 1109451
This style of adjusting screw has a ball with a flat side on the end.
Application:Part #: 1109613
Stainless steel valves are used in the big valve heads.
Application:Part #: N111521
This screw rides against your valve, opening and closing it.
Application:Part #: 1109002USA
Cam Gear without bolts USA Made
Application:Part #: 113101399B
Rocker Arm Stud
Application:Part #: 1109401125SC
1.25 Ratio Rockers Pro SCAT
Application:Part #: 1109651
We have had good luck with stock keepers on single springs.
Application:Part #: 113109309C
These ride against the cam. Sold each. You will need 8 to do an engine
Application:Part #: 1109002
Premium Performance Aftermarket Cam Gear
Application:
These tubes go from the case to the heads to house the push rods.
