Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
There are two types of sand seals. One type just bolts in, but the other style requires the case to be machined. We've had poor luck with the bolt-in style, so we machine our cases. A couple of tricks here. After you have installed the seal (machined-in) spread a thin layer of JB Weld on the seal surface to the case. This trick will keep the seal from spinning. The other trick is if you're using an aluminum pulley, be sure you machine it down and use a steel sleeve on it. If you don't, the seal will quickly wear a groove in the pulley.
Race/Off-Road: 40hp-1600
No customer reviews for the moment.
Part #: 040101157
This plug goes in the back of the case (flywheel side).
Application:Part #: 6105246
There are two types of sand seals.
Application:Part #: 113101211G
It's possible to put a generator on an alternator stand but not the other way around.
Application:Part #: 1101132
A case saver is an insert that repairs worn or stripped head stud holes in a case.
Application:Part #: 043101025
We only carry NEW dual relief cases. Limited supply!
Application:Part #: 113105245FRS
Rear Main Seal, Double Lipped
Application:Part #: N144111
Some of the most common studs you might need.
Application:Part #: 1101030
Included in this kit are the bolts, nuts and washers required for "out to head" assembly of the engine..
Application:Part #: 1198035
If you are converting a single port engine to a dual port or if you have a brand new case; these are the head studs you're looking for.
Application:Part #: 1101157
This cam plug is made out of billet alluminum and has an o-ring on it.
Application:Part #: N110104
Some of the more common nuts you might need..
Application:Part #: 111198007AF
This kit contains most of the seals and gaskets necessary to rebuild an engine.
Application:Part #: 043101129
This is the washer used under the nuts on cases that use an o-ring on the center main studs.
Application:Part #: N122412
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 113101219
It's possible to put a generator on an alternator stand but not the other way around.
Application:Part #: 111199102
This nut came on all dual relief cases.
Application:
