Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:These are used cranks with reground rod and main journals.
These are used cranks with reground rod and main journals. Each crank is checked for cracks and wallowed out dowel pin holes. We only grind to 10 under, 20 under and 30 under; any further and the bearings are getting too thick. We also grind on the high side of the scale to insure maximum life out of the crank. A 10 under crank will read 2.155; a 20/2.145, and a 30/2.135. If you mic a used crank and the last number is below a 4, then you shouldn't run it. Example: The reading you get is 2.15382. This is a worn out 10 under crank and should be turned in for a 20 under. All cranks are sold on an exchange basis, cores must be usable.
No customer reviews for the moment.
Part #: 111105279A
Flywheel to Crank Seal Paper 36 HP
Application:Part #: 111198461BR
The crankshaft rides in the main bearing.
Application:Part #: 1105261
Adjustable Timing Pointer
Application:Part #: 1105273BR
Lightened 12 lb.
Application:Part #: 111105433
Wrist Pin Bushing.
Application:Bug (Type 1); 40hp
Bus (Type 2); 40hp
KG; 40hp
Part #: 1105305
This washer is larger in diameter than stock so it gives you more surface coverage over the dowel pins.
Application:Part #: 1105425
These connecting rods are longer than stock.
Application:Part #: 1105253BK
This is a crank pulley for an upright motor.
Application:Part #: 111105259
The bolt and washer that holds the crankshaft pulley on.
Application:Part #: 113105701
These are the shells that go in the rods and ride on the crank.
Application:Part #: 113105245FS
This seal goes behind the flywheel.
Application:Part #: 113105219
Crankshaft Spacer Ring
Application:Part #: 1903108RD
EMPI Serpentine Belt System Red
Application:Part #: 311105273AN
VW Flywheel, 200mm 12 volt 15-1600cc Engines
Application:Part #: 111105227
Retaining Clip, 1200-1600cc
Application:Part #: 1105178
This crankshaft is made of E4340 chromoly forging, one of the strongest metals known to man.
Application: