Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This stock oil cooler cools the hot oil coming from the engine.
This stock oil cooler cools the hot oil coming from the engine. We recommend the doghouse style over the earlier one because the hot air exits the cooler and goes outside the engine compartment. The earlier cooler allows the hot air to go over the #3&4 cylinders, an inadequate way of cooling. Note: When installing the fan shroud over the doghouse cooler you should wrap a piece of foam over the top of the cooler to insure that air from the fan goes through the cooler and not around it. When it comes to oil cooler seals, we suggest you give us a call.
Bug (Type 1): 61-79
Bus (Type 2): 60-71
Ghia: 61-74
Thing: 73-74
Race/Off-Road: 61-79
No customer reviews for the moment.
Part #: 113198031
These gaskets are used on the sump plates of the engine.
Application:Part #: 1117111
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: 1117113
This adapter replaces the stock oil cooler with two hoses to reroute the oil to an external oil cooler.
Application:Part #: 1117698
When mounting the oil cooler above the transmission on a Bug, Type 3, Ghia, Thing, or Off Road car you can use these rubber mounted studs.
Application:Part #: 311115107AHD
The oil pump is the heart of the engine, so it is very important to choose the right one.
Application:Part #: 021117151A
This stock oil cooler cools the hot oil coming from the engine.
Application:Part #: 1115485CH
A stock cap that has been chromed for looks..
Application:Part #: 1117103
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: N121051
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 1115450PL
The oil filler extension screws into the generator stand and comes with a fitting to vent the crankcase.
Application:Part #: N115244
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 1115107AFF
26mm Oil pump for dual relief case with a flat cam. For full flowed motors only.
Application:Part #: N122412
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: JC22960
Jaycee Billet Full Flow Pump Cover w/ -8 O-ring Fitting, Blue
Application:Part #: 1115610RD
Billet Dipstick, Red
Application:Part #: JC22220
Jaycee Billet Oil Cap with Breater #8 AN Fitting, Black
Application:
This stock oil cooler cools the hot oil coming from the engine.
