Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This oil pump cover comes with a threaded boss.
This oil pump cover comes with a threaded boss. You will need to plug the outlet side of the oil pump, which will force the oil out the cover. From this cover, the oil is routed to a filter then to a cooler and back into the case. The case must be full flowed, in other words, machined for the return line. This is the optimal way to run an external cooler, while maintaining the stock cooler. We recommend using this cover with a System One oil filter and the Mesa 72 plate oil cooler. You should also use the stock 1971 on doghouse internal oil cooler. All covers are for 8mm studed oil pumps.
Bug (Type 1): All
Bus (Type 2): -67
Ghia: All
Thing: All
Race/Off-Road: All
No customer reviews for the moment.
Part #: 1115453
This stock oil filler and cap has been chromed.
Application:Part #: 1115182
A stock sump plate that has been chromed..
Application:Part #: JC21010
Jaycee Mag-Plate, 6 Bolt, Red
Application:Part #: 1115450PL
The oil filler extension screws into the generator stand and comes with a fitting to vent the crankcase.
Application:Part #: 040101149
Oil pick up Pipe
Application:Part #: 111115475A
Oil Filler Seal, 25-36 HP
Application:Part #: 311115175A
This screen fits in the sump around the pick up tube.
Application:Part #: 1115183
This plate is made out of a solid piece of aluminum.
Application:Part #: 021115311
It caps the hole you are aiming at while pouring oil over everything else.
Application:Part #: 1117105ALM
These fittings are used for the stainless steel hose.
Application:Part #: 1117110
This adapter replaces the stock oil cooler with two hoses to reroute the oil to an external oil cooler.
Application:Part #: N122412
This is a general rule for washer use, wafer washers are used against aluminum and lock washers are used against steel..
Application:Part #: 1117111
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: JC22230
Jaycee Billet Oil Cap with Breater -8 AN Fitting, Blue
Application:Part #: 1117109
This block off plate is made to loop the oil back into the case in place of the stock oil cooler.
Application:Part #: 113115451D
Oil Filler with Tube
Application:
This oil pump cover comes with a threaded boss.
