Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
If you built your motor out of a type 3 case, you probably notice that once you got it all together you're missing a dipstick tube.
If you built your motor out of a type 3 case, you probably notice that once you got it all together you're missing a dipstick tube. This block off goes on the case and has tube coming out of it so you can use a dipstick. It's not the greatest, but it'll get you out of a bind.
Bug (Type 1): 1500-1600
Bus (Type 2): 1500-1600
Ghia: 1500-1600
Thing: 1500-1600
Race/Off-Road: 1500-1600
No customer reviews for the moment.
Part #: 1117698
When mounting the oil cooler above the transmission on a Bug, Type 3, Ghia, Thing, or Off Road car you can use these rubber mounted studs.
Application:Part #: 1115141BL
This oil pump cover comes with a threaded boss.
Application:Part #: 311115541
This boot goes on the end of the dump tube.
Application:Part #: 1117024
Mesa coolers are the state of the art oil coolers.
Application:Part #: 111115495
This is more of a bolt than a nut.
Application:Part #: 1117012
These bolt on mounts allow you to bolt the filter adapter under the driver's side fender or hang it off the exhaust flange..
Application:Part #: 1117106
When plumbing the oil filter, oil cooler and/or case, these are the fittings you will need.
Application:Part #: 111115487
It caps the hole you are aiming at while pouring oil over everything else.
Application:Part #: 021115311
It caps the hole you are aiming at while pouring oil over everything else.
Application:Part #: 1117105ALM
These fittings are used for the stainless steel hose.
Application:Part #: 1115183RD
This plate is made out of a solid piece of aluminum. Red
Application:Part #: JC22950
Jaycee Billet Full Flow Pump Cover w/ -8 O-ring Fitting, Black
Application:Part #: 111115175
Oil Screen 25HP engines thru 1 677 687
Application:Part #: 1117699
When mounting the oil cooler above the transmission on a Bug, Type 3, Ghia, Thing, or Off Road car you can use these rubber mounted studs.
Application:Part #: 1115455
The smooth flow design has a nice look and comes with a knurled cross-groove or smooth billet grooved cap for a good grip when it is wet or oily.
Application:Part #: 113198031
These gaskets are used on the sump plates of the engine.
Application:
If you built your motor out of a type 3 case, you probably notice that once you got it all together you're missing a dipstick tube.
