Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This stock oil filler and cap has been chromed.
This stock oil filler and cap has been chromed. Never plug the draft tube! The crankcase relieves it's pressure through the draft tube. If you plug the tube, oil will just blow out somewhere else. Note: Always run a dump tube boot on the end of the tube or your engine will eat dirt. On most off-road cars we put on the oil filler that does not have a down tube. In doing this it is real important that you run a breather filter. We usually run a hose up to the filter and mount it above the engine. On street cars we run the filler that has a tube.
Race/Off-Road: 40hp-1600
No customer reviews for the moment.
Part #: 113115451D
Oil Filler with Tube
Application:Part #: 1115453
This stock oil filler and cap has been chromed.
Application:Part #: 113115475
It's possible to put a generator on an alternator stand but not the other way around.
Application:Part #: 1115141
This oil pump cover comes with a threaded boss.
Application:Part #: 1117106ALM
These fittings are used for the stainless steel hose.
Application:Part #: 1115464
This air filter is made to protect the crankcase.
Application:Part #: 1117109
This block off plate is made to loop the oil back into the case in place of the stock oil cooler.
Application:Part #: 1117007
This is the high-temp/pressure hose used for routing oil to coolers and filters.
Application:Part #: 1117699
When mounting the oil cooler above the transmission on a Bug, Type 3, Ghia, Thing, or Off Road car you can use these rubber mounted studs.
Application:Part #: 61151062C
Clamps for Engine Oil Accumulator 2 QT capacity
Application:Part #: 1115421
These stronger springs were designed to boost the oil pressure in your motor.
Application:Part #: 111117151
This stock oil cooler cools the hot oil coming from the engine.
Application:Part #: 1117101ALF
These fittings are used for the stainless steel hose.
Application:Part #: JC21030
Jaycee Mag-Plate, 6 Bolt, Blue
Application:Part #: 1115183BL
This plate is made out of a solid piece of aluminum. Blue
Application:Part #: 111115107AK
VW flat cam, 21mm, 8mm Stud Oil Pump
Application:
This stock oil filler and cap has been chromed.
