Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Whether your motor lives or not can depend upon this little shim.
Whether your motor lives or not can depend upon this little shim. Many people tend to overlook this part, but the shim controls the compression ratio. Compression equals heat and heat destroys motors. Take the time to figure your compression ratio and get the proper shims for that desired compression. Figuring compression ratios and getting the right shims is a long subject, so for help, just call. We find that 99.9% of all engines need barrel shims. Shims are sold in sets of 4.
Bug (Type 1): 1600
Bus (Type 2): 1600
Type 3: 1600
Ghia: 1600
Thing: 1600
Race/Off-Road: 1600
No customer reviews for the moment.
Part #: 1101344
36 HP Barrel Shims .040 (4)
Application:Part #: 311198069F
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 113101353ECO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 1198162TS
92mm Piston Rings 1.5x2x4 Total Seal
Application:Part #: 1198162
These rings are cast iron.
Application:Part #: 1198162A
These rings are cast iron.
Application:Part #: 043101457
These nuts and washers hold the heads on.
Application:Part #: N14402140
Some of the most common studs you might need. Stud 8mm x 40mm
Application:Part #: 1101468
If you have high compression you will need to vent the valve covers into a breather box.
Application:Part #: 111101401B02
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1198163A
These rings are cast iron.
Application:Part #: 043101421
Exhaust Valve Guide 9mm
Application:Part #: 1198159B
These rings are cast iron.
Application:Part #: 113101353BRB
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld). Due to a shortage of cores we will need your Cylinder head Cores before sending any Rebuilt heads.
Application:Part #: 1101474
These covers look good but have a tendency to leak.
Application:Part #: 1107433
Not our favorite type of piston pin keeps.
Application:
Whether your motor lives or not can depend upon this little shim.
