Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Whether your motor lives or not can depend upon this little shim.
Whether your motor lives or not can depend upon this little shim. Many people tend to overlook this part, but the shim controls the compression ratio. Compression equals heat and heat destroys motors. Take the time to figure your compression ratio and get the proper shims for that desired compression. Figuring compression ratios and getting the right shims is a long subject, so for help, just call or go to our tips and find the article I wrote on it. We find that 99.9% of all engines need barrel shims. Shims are sold in sets of 4.
No customer reviews for the moment.
Part #: 1101399
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1198159
These rings are cast iron.
Application:Part #: 1101393
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1107432
Not our favorite type of piston pin keeps.
Application:Part #: N110085
Some of the more common nuts you might need..
Application:Part #: 1198161TS
90.5mm Piston Rings 1.5x2x4 Total Seal
Application:Part #: 1107431
There are two types of keepers we like to use.
Application:Part #: 113101353BCO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 1101355P
Here's another long subject, but it'll give you a little something to think about.
Application:Part #: 111198157A
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 113101353ECO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 311198169B92
Piston Ring Set 92mm
Application:Part #: 311101353A
New single port head.
Application:Part #: 1101481
These are great valve covers gaskets.
Application:Part #: N154011
These nuts and washers hold the heads on.
Application:Part #: 1101346
36 HP Barrel Shims .060 (4)
Application:
Whether your motor lives or not can depend upon this little shim.
