Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld). Bad guides are replaced and new exhaust valves are installed along with a three angle valve job. All heads are bead blasted and measured for cc volume. Flycutting is done if needed. Note: It is better to buy these in pairs so we can match up a pair by cc's. The amount of cc's greatly affects the compression ratio. We do not believe in head shims, but recommend barrel shims to lower the compression ratio. CORES FOR REBUILT HEADS MUST NOT HAVE CRACKS OR WELDS.
Bug (Type 1): 1600
Bus (Type 2): 1600
Type 3: 1600
Ghia: 1600
Race/Off-Road: 1600
No customer reviews for the moment.
Part #: 043101457
These nuts and washers hold the heads on.
Application:Part #: 1101475CH
These are just stock valve covers that are chrome.
Application:Part #: 1101372
40 HP Barrel Shims .020 (4)
Application:Part #: 1198163A
These rings are cast iron.
Application:Part #: 043101421
Exhaust Valve Guide 9mm
Application:Part #: 1101446
This is a shim that is used between the head and barrel.
Application:Part #: 311198169B92
Piston Ring Set 92mm
Application:Part #: 1198094B
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 1198087
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 111101401B
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1101374
40 HP Barrel Shims .040 (4)
Application:Part #: 1101344
36 HP Barrel Shims .040 (4)
Application:Part #: 311198169A
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 1198094BWVP
Wiseco 94mm with Valve Pockets Pistons & Cylinders
Application:Part #: 111101461
These nuts and washers hold the heads on.
Application:Part #: 1101357
Whether your motor lives or not can depend upon this little shim.
Application:
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
