Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld). Bad guides are replaced and new exhaust valves are installed along with a three angle valve job. All heads are bead blasted and measured for cc volume. Flycutting is done if needed. Note: It is better to buy these in pairs so we can match up a pair by cc's. The amount of cc's greatly affects the compression ratio. We do not believe in head shims, but recommend barrel shims to lower the compression ratio. CORES FOR REBUILT HEADS MUST NOT HAVE CRACKS OR WELDS.
Bug (Type 1): 1600
Bus (Type 2): 1600
Type 3: 1600
Ghia: 1600
Thing: 1600
Race/Off-Road: 1600
No customer reviews for the moment.
Part #: 1107435
Not our favorite type of piston pin keeps.
Application:Part #: 1101399
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1109604
Valve seats are used in the big valve heads.
Application:Part #: 1101481
These are great valve covers gaskets.
Application:Part #: 315198163A
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 1198094A
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 1198092A
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 11310140102
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1101389
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 111198157A
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 1198092BCH
92mm Pistons & Cylinders set with a 82mm Stroke CHINA
Application:Part #: 1101448
This is a shim that is used between the head and barrel.
Application:Part #: 1101384
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1107434
Not our favorite type of piston pin keeps.
Application:Part #: 1107433
Not our favorite type of piston pin keeps.
Application:Part #: 1101474
These covers look good but have a tendency to leak.
Application:
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
