Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Rings on the pistons are there to eliminate "blow-by".
Rings on the pistons are there to eliminate "blow-by". To see if your cylinders or rings are worn out, take a top ring and place it into the cylinder about an inch down from the top. Using a piston with no rings, push the ring down making sure it is sitting flat in the cylinder. With the ring in the cylinder, use a feeler gauge to measure the ring gap. If it is over .030", either the ring or the cylinder is worn out. If you feel a ridge on the top of the cylinder, then it's a bad cylinder and time for a new set of pistons and cylinders. We prefer using cast rings instead of chrome rings. Chrome rings never seem to seat. This causes a lot of "blow-by". Note: Use ring spreader pliers to put the rings on. When putting the cylinders on, make sure none of the ring gaps are lined up.
No customer reviews for the moment.
Part #: 1198162
These rings are cast iron.
Application:Part #: 1107433
Not our favorite type of piston pin keeps.
Application:Part #: 1101477BL
These covers look good but have a tendency to leak.
Application:Part #: 113101353ECO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 1198083
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 1101474
These covers look good but have a tendency to leak.
Application:Part #: 1101482
These covers look good but have a tendency to leak.
Application:Part #: 1198094BWVP
Wiseco 94mm with Valve Pockets Pistons & Cylinders
Application:Part #: 1101462KIT
This kit has the correct nuts and washers to hold the heads on the engine..
Application:Part #: 1198092A
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 113101353BRB
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld). Due to a shortage of cores we will need your Cylinder head Cores before sending any Rebuilt heads.
Application:Part #: 1101473OR
These covers look good but have a tendency to leak.
Part #: 043101457
These nuts and washers hold the heads on.
Application:Part #: 1198087
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 1109604
Valve seats are used in the big valve heads.
Application:Part #: 1101372
40 HP Barrel Shims .020 (4)
Application:
Rings on the pistons are there to eliminate "blow-by".