Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N109052
Screws for replacement pop out window frames. These screws are for joining the two Popout frame halves together
Application:
These nuts and washers hold the heads on.
These nuts and washers hold the heads on. The washers are thick so they won't deform under heat and torque. The torque on 10mm nuts is 28 ft. lb. and the 8mm nuts is 18 ft.lb. One trick is to use 3M glue on the bottom of the washers in the rocker area to prevent leaking through the head.
Bug (Type 1): All
Bus (Type 2): All
Type 3: All
Ghia: All
Thing (Type 5): All
Race/Off-Road: All
No customer reviews for the moment.
Part #: 1101476
These are great valve covers.
Application:Part #: 1198094A
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 1101469
If you have high compression you will need to vent the valve covers into a breather box. Deluxe Vents have barbed end for the hose connection.
Application:Part #: 113101355A
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:Part #: 1198162A
These rings are cast iron.
Application:Part #: 1101473OR
These covers look good but have a tendency to leak.
Part #: 111101401B02
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 070198169
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 1101391
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1109398
These rocker studs are much stronger than the stock studs and are .100" longer to allow more flexibility when setting your rocker arm geometry..
Application:Part #: 1198092B
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 1101346
36 HP Barrel Shims .060 (4)
Application:Part #: 1198094C
94mm Mahle Barrels
Application:Part #: 1198161TS
90.5mm Piston Rings 1.5x2x4 Total Seal
Application:Part #: 1101482
These covers look good but have a tendency to leak.
Application:Part #: 1101351
Whether your motor lives or not can depend upon this little shim.
Application:
These nuts and washers hold the heads on.
