Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
Not our favorite type of piston pin keeps.
Not our favorite type of piston pin keeps. There good for a friday saturday car. The reason we dont like them is after many miles they tend polish the sides of the barrel. Rings will not seat on a polished surface. Sold in sets of 8.
Bug (Type 1): 1600
Type 3: 1600
Ghia: 1600
Thing: 1600
Race/Off-Road: 1600
No customer reviews for the moment.
Part #: 1101342
36 HP Barrel Shims .020 (4)
Application:Part #: 111198157B
Rings on the pistons are there to eliminate "blow-by".
Application:Part #: 1198094B
All kits come with pistons, cylinders, rings, wrist pins and clips.
Application:Part #: 1107431
There are two types of keepers we like to use.
Application:Part #: 1109398
These rocker studs are much stronger than the stock studs and are .100" longer to allow more flexibility when setting your rocker arm geometry..
Application:Part #: 1101353
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 11310140108
If you're rebuilding your own heads, you will probably need guides.
Application:Part #: 1198161TS
90.5mm Piston Rings 1.5x2x4 Total Seal
Application:Part #: 1101462KIT
This kit has the correct nuts and washers to hold the heads on the engine..
Application:Part #: 111109623
25/36 HP Valve Springs (Set of 8)
Application:Part #: 043101457
These nuts and washers hold the heads on.
Application:Part #: 111198057
These come in sets of four pistons with rings, four cylinders, four wrist pins and eight wrist pin keepers.
Application:Part #: 1101354
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1101381
Whether your motor lives or not can depend upon this little shim.
Application:Part #: 1101484
This is like a stock gasket except it is made out of rubber instead of cork.
Application:Part #: 113101355ACO
All of our rebuilt cylinder heads are built from non-cracked or non-welded head cores (rebuilt welded heads will usually crack again next to the weld).
Application:
Not our favorite type of piston pin keeps.
