Part #: N109051
Side Popout Window Frame Screws (3.5mmX6mm) Frame to Hinge
Screws for replacement pop out window frame to hinge
Application:- Bus (Type 2): -67
Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This is the front of the transmission that houses the shift lever.
This is the front of the transmission that houses the shift lever. Used ones are fine as long as the bushings are good and they're not cracked. Note: Use a new gasket with Gasgacinch for a sealer. Don't over tighten the 11mm nuts. For those of you who are putting a syncro style trans into a 53-59 Bug, you'll need the Bus nose cone and front mount. Those of you with a 60 Bug, punt.
Bug (Type 1): 66-72
Type 3: 66-72
Ghia: 66-72
Race/Off-Road: 66-72
No customer reviews for the moment.
Part #: 111301257
Transmission Horn Bolt
Application:Part #: 113517289A
These are the seals that go around the final drives on an IRS transmission.
Application:Part #: 311301343
Sleeve
Application:Part #: 6501141
These retainers help stiffen the plates that bolts the tubes to the trans.
Application:Part #: 1311123
This steel thrust plate stops movement of the main shaft bearing and aids in the keepin the alignment of the gears on the main and pinion shafts.
Application:Part #: 113301155
This is the bushing between the bellhousing of the transmission and the starter.
Application:Part #: 113301264
These rubber mounts hold the transmission in place.
Application:Part #: 113517191
Swing Axle Fulcrum Plates
Application:Part #: N122391
Transmission Cradle Bolt Washer
Application:Part #: 001301207
Nose Cone Bushing, Rear, Late
Application:Part #: 001301209C
Nose Cone Seal Holder
Application:Part #: 1301048I
Padded Trans Support Front Kit
Application:Part #: 113301185A
This kit contains all of the gaskets needed to rebuild a transmission.
Application:Part #: 111398005A
This kit contains all of the gaskets needed to rebuild a transmission.
Application:Part #: 211301297
Front Transmission Mount
Application:Part #: 1301265
These mounts made of urethane never wear-out.
Application:
This is the front of the transmission that houses the shift lever.