Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
This plastic ball goes in the nose cone of a 68-79 bus transmission. There isn't a good way to tell if yours is worn out other than taking the nose cone off, but before taking it off, make sure your trans is in neutral. As you pull the nose cone off, push the hockey stick through it as you go. Now pull the hockey stick out of the ball. Turn the ball sideways in the selector rod and pull it out. Take the new ball, grease it with some white grease and install it in the selector rod. Put a new gasket on the transmission housing and slide the hockey stick just past the nose cone mating surface. Engage the hockey stick into the ball and slide the nose cone on the rest of the way and tighten it.
Bus (Type 2): 68-79
No customer reviews for the moment.
Part #: 211501293A
This nut goes on the inner side of the lower axle shaft of your large nut (46mm) recution boxes.
Application:Part #: 113311113A
This seal goes around the mainshaft.
Application:Part #: 211501273A
This gasket goes between the reduction box halves.
Application:Part #: 003301089D
Front Torque Converter Seal for Automatic Transmission
Application:Part #: 002301189C
These are the seals that go around the final drives on an IRS transmission.
Application:Part #: 211301205H
This is the front of the transmission that houses the shift lever.
Application:Part #: 211301215
This is the front of the transmission that houses the shift lever.
Application:Part #: 113301185A
This kit contains all of the gaskets needed to rebuild a transmission.
Application:Part #: 1301048I
Padded Trans Support Front Kit
Application:Part #: 2311123
This steel thrust plate stops movement of the main shaft bearing and aids in the keepin the alignment of the gears on the main and pinion shafts.
Application:Part #: 091301189A
Transmission to drive flange seal. Left or right
Application:Part #: 211301265A
These rubber mounts hold the transmission in place.
Application:Part #: 211301289A
Nose Cone Boot
Application:Part #: 2301150
This is a bolt on kit that reduces torsional stress felt at the front of the nose cone mount and rotational stress on the bell housing mounts.
Application:Bus (Type 2); 56-67
Part #: 113301229A
This is the front of the transmission that houses the shift lever.
Application:
