Part #: N109051
Screws for replacement pop out window frame to hinge
Application:Part #: 211837659
This nylon washer goes on the wing bolt keeping the bolt from chewing up the slide on the safari window. Washers sold individually 8 are required for Front Safaris and 4 are required for Rear Safaris.
Application:Part #: N107101
This is a list of the most common screws you might need..
Application:Part #: N185164
Screws for replacement pop out window Latches to Body
Application:Part #: N139681
This is a list of the most common screws you might need..
Application:Part #: N203551F
These are new hoses that are more resistant to Ethanol, meaning they last longer. This type of hose is what we now recommend.
Application:
These mounts should only be used on cars that are not daily drivers.
These mounts should only be used on cars that are not daily drivers. The good thing about them is the trans doesn't move. The bad thing is they are hard on parts and transmit a lot of noise into the car.
Race/Off-Road: 61-72
No customer reviews for the moment.
Part #: 001301209A
Nose Cone Seal Holder
Application:Part #: 6501141
These retainers help stiffen the plates that bolts the tubes to the trans.
Application:Part #: 6301150A
Type 2 Transmission Center Mount Only
Application:Part #: 1301049
These straps are a good idea if you have a car with a big engine.The rear strap keeps the bell housing from twisting and the front strap keeps the nose of the transmission from breaking the front mount.We highly recomend that you use these in conjunction with the urethane transmission mounts.
Application:Part #: 111301155
This is the bushing between the bellhousing of the transmission and the starter.
Application:Part #: 6301267
Front Transmission Solid Mount with Hardware
Application:Part #: 1301265L
Urethane Front Transmission mount with Hardware
Application:Part #: 113517289A
These are the seals that go around the final drives on an IRS transmission.
Application:Part #: 113311123A
This is the main culprit of a noisy transmission.
Application:Part #: 111301289B
This boot goes around the nose cone to seal up the hole where it comes through the pan.
Application:Part #: 1301184
This heavy duty side plate keeps the ring and pinion where it's supposed to be.
Application:Part #: 1301150
Bolt on Center Transmission mount, Urethane stops included
Application:Part #: 001301207
Nose Cone Bushing, Rear, Late
Application:Part #: 211301215
This is the front of the transmission that houses the shift lever.
Application:Part #: 6711174
Aligns Type 1 Shift Shaft to Type 2 Transmission Coupler, Aluminum
Application:
These mounts should only be used on cars that are not daily drivers.
